GB-14
Preparation Connections Initial Setup Using the Features EPG (Electronic
Programme Guide)
Using the DVD Features Hints and Tips, Specification
and Safety Warnings
Connecting a SPDIF Audio Receiver
For better sound quality, you may want to play the
DVD audio through your multi-channel audio receiver.
1. Use an audio cable to connect the TV’s SPDIF
output socket to an external audio receiver’s
audio SPDIF input socket.
2. Plug the connected devices into the mains socket
before switching on the POWER ON/OFF switch
at the bottom of the TV.
3. Press the button on the side panel of the TV or
on the remote control to turn on your TV and your
audio receiver and then select SPDIF to "ON" in
the SOUND menu of your TV.
The TV's volume control will have no effect.
You may control the audio level via the Audio
Receiver.
Rear View of TV
Audio Cable
(not included)
VGA INPUT
Y Pb Pr
L R SPD IF
AUDIO
VGA INPUT
SCART
HDMI 1
HDMI 2
ANT
100 -240V ~ 50/60H z
AC- INPUT
COM MON I NTERF ACE
CAR D FAC E FRO NT
VGA INPUT
Y Pb Pr
L R COAXIA L
AUD IO
VGA I NPUT
SCA RT
HDM I 1
HDM I 2
ANT
100 -240V ~ 50/6 0Hz
AC- INPUT
COMM ON IN TERFA CE
CARD FACE FRON T
OR
Connecting the Aerial
Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the RF (75Ω) socket at the bottom of your TV.
Do not connect the TV to the mains supply
until you have completed all the connections.
RF coaxial cable
(not included)
L26DIGB10_IB_final110210_running change6.indd 14 10/02/2011 3:12 PM
To Next Page
Loading...
Need help?
General
