25
Internal Care
Filtering System
The filtering system in the base of the wash cabinet captures large particles of suds solution. Build up of
these particles may cause the filters to block. Check the condition of the filters regularly and clean them if
necessary under running water.
Follow the steps below to clean the filters in the wash cabinet.
1. Ensure the dishwasher is switched off.
2. Unscrew the coarse filter, and gently lift it out.
3. Carefully lift the main filter out.
4. Carefully lift the fine filter out.
5. Rinse all the filters under running water, then refit all filters in the following order.
6. Carefully refit the fine filter with filter.
7. Carefully refit the main filter.
8. Gently screw in the course filter in a clockwise direction.
Cleaning After Use
External Care
The Door and the Door Seal
1. Clean the door seals regularly with a soft damp cloth to remove food deposits.
2. When the dishwasher is being loaded, food and drink residues may drip onto the sides of the
dishwasher door. These surfaces are outside the wash cabinet and are not accessed by water from the
spray arms. Any deposits should be wiped off before the door is closed.
The Control Panel
If cleaning is required, the control panel should be wiped with a soft damp cloth ONLY.
Filter cylinder
without the lters
• To avoid penetration of water into the door lock and electrical components, do not use a
spray cleaner of any kind.
• Never use abrasive cleaners or scouring pads on the outer surfaces because they may scratch
the finish. Some paper towels may also scratch or leave marks on the surface.
• Do not over tighten the filters. Put the filters back in the filter cylinder in sequence securely,
otherwise the residue could get into the system and cause a blockage.
• NEVER use the dishwasher without the filters in place. Improper replacement of the filters
may reduce the performance level of the appliance and damage dishes and utensils.
LDW45S11_IB_110331.indd 25 3/31/11 5:04 PM
To Next Page
Loading...
Need help?
General
