18
1. Remove the lower basket and unscrew the reservoir cap.
Adding Salt
If the water in your area is hard, deposits will form on your dishes and utensils. This appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and it must be set to
correspond to the water hardness level in your area.
2. Fill the reservoir with approximately 500ml of water (rst
use only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt depending
on the brand used.
5. Clean any excess salt from around the reservoir opening
and then screw the cap on again rmly.
6. Run the “Rapid” wash programme immediately (without
any crockery in the dishwasher) to remove any traces of
salt from the compartment.
• The salt warning light will illuminate when the
reservoir is running out of salt and requires re-lling.
• The salt warning light will cease to illuminate within a
few days depending on how quickly the salt dissolves.
open
open
open
LID45W20_IB_Final200727.indd 18LID45W20_IB_Final200727.indd 18 27/7/2020 4:23 PM27/7/2020 4:23 PM
To Next Page
Loading...
Need help?
General
