27
Switching O the Unit
To save energy, remember to switch the dishwasher o using the ON/OFF button. The
dishwasher will continue to use electricity until it is switched o.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip
more easily when they are hot. Therefore, if you open the dishwasher door fully after switching
o, it will allow the dishes to cool down much faster.
Delay Start
The starting time of a wash programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Press the ON/OFF button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the Delay button.
5. Set the required delay start time using the delay button.
6. Close the door and the unit will start the programme at the assigned time automatically.
• Unload the lower basket rst, followed by the cutlery basket and then the upper
basket.
• This will prevent water drops from the upper basket from falling on to the dishes in
the lower basket.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday,
disconnect the unit from the mains supply.
Half Load
In case you do not have enough dishes for a full load, the half load option can be selected. This
will save hot water and electricity usage. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery onto the basket.
2. Press the ON/OFF button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the 1/2 button, the half load indicator will light up.
5. Close the door and the unit will start the programme.
LID45W20_IB_Final200727.indd 27LID45W20_IB_Final200727.indd 27 27/7/2020 4:23 PM27/7/2020 4:23 PM
To Next Page
Loading...
Need help?
General
