6
LOGITECH HARMONY LINK USER MANUAL
6. Adding devices
After you have collected the model numbers for your entertainment devices, you can
begin adding them to your Harmony account. You can use your Harmony Link app to
control up to 8 devices.
Note:
If you add the wrong device, you can remove it once initial setup is complete.
My Harmony will walk you through the process of setting up your devices. You’ll be asked
to provide the manufacturer name and model number for each entertainment devices
you want to control with your Harmony Link app.
You can use the
Device worksheet on page 5 to gather the necessary information.
For devices with multiple inputs (like TVs and AV receivers), you’ll need to note which
devices are connected to them, and with which inputs.
Teaching commands using your original remote
If My Harmony doesn’t recognize the brand and model number of the device you’re
trying to add, you can use the original device remote to teach its commands so you can
control the device. Your Harmony Link has an IR sensor so it can learn commands from
your original remote.
Before you can begin teaching, you must connect your Harmony Link to your computer
using the USB cable provided, and plug your Harmony Link into a power supply.
Note:
Harmony Link may take up to a minute to fully power up before you can begin teaching.
Follow the on-screen instructions to position the remote and your Harmony Link for
teaching. Make sure you point the original remote at the Logitech logo on your Harmony
Link at a 45 degree angle, about 4-5 inches (or 10-12 centimeters) away.
You’ll be asked to press one or more buttons on the original remote. Press and release
the button as you normally would. Do not press and hold the button. If you can’t fi nd the
To Next Page
Loading...
Need help?
General
