9
Transporter™ Owner’s Guide
WEP keys consist of a string of ten or twenty-six digits or letters A through F.
WPA passwords are a string of letters, numbers or punctuation.
Enter the subnet mask for the network, the default gateway IP address, and the
address of your DNS server, pressing the arrow on the remote to move to
each one.
If you are having trouble connecting to your wireless network, check the
Frequently Asked Questions section at the end of this guide.
1. If SlimServer isn’t already running, start it now.
Transporter will scan your local network to nd the computer that’s running
SlimServer. If you started SlimServer after conguring Transporter, you may need
to scroll to nd it.
If SlimServer is running on your computer and you don’t see it in this menu,
check the Troubleshooting section at the end of this guide and make sure that
any rewall software you have installed is congured properly.
You can also choose to connect to the SqueezeNetwork internet service. See the
SqueezeNetwork section of this guide for more information.
2. Select the computer you want to use. If you are running SlimServer on multiple
computers on your local network, you can use the arrow to scroll to the
one you want to use.
3. Press the arrow on the remote to connect.
Setup is complete.
If you want to go back to setup later press the arrow on the remote
down and hold it for ve seconds. Transporter will return to the
menu.
To Next Page
Loading...
Need help?
General
