Lorentz PS150 Series User Manual

7.7.1.2 Pump Wiring
The motor cables of the pump have a marking to allow
correct wiring. Connect the wires using this sequence:
 1: Motor cable L1
 2: Motor cable L2
 3: Motor cable L3
 : GND
If necessary, interchange any two phases to reverse direc-
tion. Refer to chapter “8 Pump Installation” on page 36
for detailed pump installation instructions.
26 Controller Installation
Controller Installation 27

Lorentz PS150 Series Specifications

General

Brand	Lorentz
Model	PS150 Series
Category	Water Pump
Language	English