Lumiax Magic Series User Manual

4.2 Accessories(Included)
Accessory
Local temperature sensor
Battery voltage sensor terminal
AUX terminal
Load control relay1 terminal
Utility/Generator relay2 terminal
Mounting screws
RS485 interface cable
Model
2P-3.81mm
2P-5.08mm
2P-3.81mm
2P-3.81mm
2P-3.81mm
M8*40mm
RJ11*1m
Number
1Pcs
1Pcs
1Pcs
1Pcs
1Pcs
4Pcs
1Pcs
Item
1
2
3
4
5
6
7
1. The connection polarity is irrelevant.
2. If the external temperature sensor is not connected or damaged, the internal
temperature will be used for temperature compensation during charging.
3. If the controller and battery are not located in the same room then an
external temperature sensor for measuring the battery temperature must be
installed.
4.3
4.3.1 Remote Temperature Sensor
Accessories(Optional)
The controller is shipped with a temperature sensor of length 80mm. If you need other
components you need to purchase separately.
The remote temperature sensor can measure the temperature at the battery and use this data
for very accurate temperature compensation. The standard length of the cable is 3m (length
can be customized). The temperature sensor connected via interface ⑩.
4.3.2 IoT module
After the controller is connected with the IoT module through the IoT interface, the
operating status and related parameters of the controller can be changed and monitored by
the mobile APP software or PC program.
Please contact with our sales about IoT wireless communication information.
7
4.1.4 RS485
The charger is equipped with a RS485 port with RJ11 sockets, the RJ11 interface is defined as
follows:
RJ11 for controller
1
2 3
4 5
6
NC RS485-B RS485-A NC NC NC
Pin No.
Definition
1
NC
NC
NC
RS485-A
RS485-B
NC
2
4
3
5
6
The RS485 interface on this charger is not galvanically isolated and can not be
grounded. Do not short circuit unused pin (Note NC).

Lumiax Magic Series Specifications

General

Brand	Lumiax
Model	Magic Series
Category	Controller
Language	English