30
31
32
29
Causes and SolutionsProblem
Eliminate Fault
Care and Maintenance
Care
Maintenance
Care and Maintenance
Troubleshooting Troubleshooting
CorrectionCauseSymbol
Error Indicators
The following symbol will appear on the display when measuring abnormally.
NOTICE: Store the unit in a clean,
dry location. DO NOT subject the unit
to extreme hot or cold temperature,
humidity, or direct sunlight.
Blood pressure varies constantly. Many
factors including stress, time of day, how
you wrap the cuff, etc., may affect your
blood pressure. Review the sections
"Proper Measurement Method" and
"Take a Measurement".
Check the battery installation for proper
placement of both battery polarities
Measurement values
appear too high or too low
Nothing appears on the
display
No power
Replace both worn batteries with new ones
NOTICE: Avoid subjecting the monitor to strong shocks or vibrations, such as
dropping the unit on the floor.
NOTICE: Use the unit in accordance with the instructions provided in this
manual. Use only authorized parts and accessories.
Keep the unit in the storage case
when not in use.
Clean the unit with a soft dry cloth.
NOTICE: DO NOT use any abrasive
or volatile cleaners.
NOTICE: DO NOT immerse the unit
or any components in water.
Maintenance
naphtha
thinner
gasoline
NOTICE: Remove the batteries if the
unit will not be used for 3 months or
longer. Always replace both batteries
with new ones at the same time.
NOTICE: DO NOT wet the cuff or
attempt to clean the cuff with water.
NOTICE: DO NOT clean the body or cuff with
solvents, naphtha, thinner or gasoline etc.
+
+
-
-
Wrap the cuff correctly
Inflate again, ensuring cuff is
wrapped correctly
Measure again, ensuring correct
procedure
Do not move your arm or body;
remain still and quiet
Battery power is too
low
Inflation error
Measurement has
failed
Replace both worn batteries with
new ones
To Next Page
Need help?
General
