MAAX Coleman Spas 630 Series User Manual

13
Temperature
Te mperature
The highest temperature that can be set is
40 °C and the lowest is 26 °C. The actual
water temperature is shown on the display.
If the pump is not used, two stripes can be
seen. If stripes are displayed, you must first
start the pump by pressing on the JETS 1
button. Then wait until the water temperature
is displayed (this takes about 2 minutes).
The set temperature of your spa can be easily
increased or decreased at any time by pressing
on the SET UP or SET DOWN buttons.
Whenever these buttons are used, the set
temperature is displayed in the LCD window.
Each time the button is pressed, the temperature
is adjusted up or down by 0.5 °C. After three
seconds, the LCD display will automatically
show the water temperature or stripes.
If the spa is in Standard mode or in a filter
cycle, adjusting the temperature can result in the
activation of the heater. Whenever the heater is
active, the word HEAT is displayed in the LCD
screen. (430 series: the Heat On indicator glows
red or blinks when the temperature is changed).
NOTE:
230 Volt spas are not heated if pump 1 is
set at high speed and/or pump 2 is in use.
JETS 1 (430 series: Low-speed Jets)
Press JETS 1 to activate the main filtration
pump. The order of the jet action is:
touch 1x = low-speed jets
touch 2x = high-speed jets
touch 3x = off
JETS 2 (430 series: High Jets)
Press JETS 2 to activate the therapeutic pump.
The order of the jet action is:
touch 1x = high-speed jets
touch 2x = off
JETS 3 (only 736 series)
See the instructions for Jets 2
The use of pump 1 at slow speed is timed so
that the pump turns of automatically after four
hours. The use of pump 1 at high speed and
pump 2 at low and high speed is timed so
that the pumps turn off after 30 minutes.
NOTE:
Pump 1 automatically works at low speed
whenever a filter cycle or heating is required.
If the pump is automatically activated, the
low speed of pump 1 cannot be turned off;
however, all other control functions can
be activated.
Locking temperature function
(only 630/736 series)
If you have set the desired water temperature,
you can fix the new setting to prevent the spa
temperature from being changed without your
knowledge. You can lock the set temperature
as follows:
Press on SET UP or SET DOWN and then
on TIME and JETS 1 (736 series: JETS 3).
You will now see the following text in the
centre of the display:
LOCF

MAAX Coleman Spas 630 Series Specifications

General

Brand	MAAX
Model	Coleman Spas 630 Series
Category	Hot Tub
Language	English