08
Spa system components
Spa components
Purely for reference. The equipment may look
different from what is shown in the picture.
NOTE:
The equipment contains no user-serviceable
components. We recommend that you have
your spa maintained and repaired only by an
experienced engineer.
A. Pumps (one or two pumps, depending
on the model): Low speed for efficient water
circulation when filtering and heating; high
speed for maximum jet operation. The pump
functions are activated using the buttons on
the operating panel.
B. Warning and installation label: Contains
important safety information and installation
instructions.
C. Sliding valves: Used to stop the flow of water
from the spa to the equipment during mainte-
nance. The number of valves depends on the
model. In normal operation all valves must be
open.
D. Electrical connections: Contains electrical
connection points for various plugs. The
electrical connection points are attached during
production.
E. Heating installation: Regulated by the
thermostat and contains a built-in safety
provision that automatically cuts out if the
heating installation overheats.
To Next Page
Loading...
Need help?
General
