5
SAFETY
Understand that your safety and the safety of other persons is measured by how you service
and operate this loader. Know the position and operations of all controls before you try to
operate. Make sure you check all controls in a safe area before starting.
Read this manual completely and thoroughly and make sure you understand all controls. All
equipment has a limit. Make sure you are aware of the stability and load characteristics of this
loader before you begin operation.
The safety information given in this manual does not replace any safety codes, insurance
needs, federal, state and local laws. Make sure your machine has the correct equipment
required by your local laws and regulations.
This safety alert symbol indicates important safety
messages in this manual. When you see this symbol,
carefully read the message that follows and be alert to the
possibility of personal injury or death.
SAFETY PRECAUTIONS
Before starting the engine of your tractor, make sure all operating controls are in park lock or
neutral position
Operate controls only when seated in the operator’s seat.
Equip your tractor with a ROPS cab or frame for your protection. See your tractor operator’s
manual for correct seat belt usage.
A frequent cause of personal injury or death is persons falling off and being run over. Do not
permit others to ride on your tractor. Only one person, the operator, should be on the machine
when it is in operation.
Before leaving the tractor, stop the engine, put all controls in neutral, engage the parking brake
and remove the key from the ignition.
When using remote hydraulic tractor valves on some tractors, the loader lift and dump cylinders
will continue moving unless the control levers are manually returned to neutral, or until relief
pressure is reached at the ends of piston strokes. Observe the bucket movement and maintain
control with the control levers.
Stop the loader arms gradually when lowering or lifting loads.
Stay off of slopes too steep for safe operation. Shift down before you start up or down a hill with
a heavy load. Avoid “free wheeling”.
16 Series, Model - 2816
To Next Page
Loading...
Need help?
General
