10
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Cleaning
After use, remove wax, chips and dust from the tool, wheel
tires and blade.
CAUTION:
• Never use solvents such as turpentine, gasoline,
lacquer, etc. to clean plastic parts.
• Wax and chips on the tires may cause the blade to slip
and come off unexpectedly. Use a dry cloth to remove
wax and chips from the tires.
Replacing tires on wheels
When the blade slips or does not track properly because of
badly worn tires, or the lip of the tire on motor side gets dam-
aged, the tires should be replaced.
Replacing fluorescent tube
CAUTION:
• Always be sure that the tool is switched off and
unplugged before replacing the fluorescent tube.
• Do not apply force, impact or scratch to a fluorescent
tube, which can cause a glass of the fluorescent tube to
be broken resulting in a injury to you or your bystanders.
• Leave the fluorescent tube for a while immediately after
a use of it and then replace it. If not. You may burn
yourself.
Remove screws, which secure Lamp Box for the light.
Pull out the Lamp Box keeping pushing lightly the upper posi-
tion of it as illustrated on the left.
Pull out the fluorescent tube and then replace it with Makita
original new one.
1. Wheel
2. Tire
3. Lip
1
2
3
004750
1. Fluorescent tube
2. lump box
3. Tapping screw
1
2
3
005905
To Next Page
Loading...
Need help?
General
