7
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be
careful not to scratch the lens of lamp, or it may lower
the illumination.
• Do not use thinner or gasoline to clean the lamp. Such
solvents may damage it.
• After operation, always turn off the light by pressing .the
“O (OFF)” side.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the blade
CAUTION:
• Oil on the blade can cause the blade to slip or come off
unexpectedly. Wipe off all excess oil with a cloth before
installing the blade.
• Use caution when handling the blade so that you are not
cut by the sharp edge of the blade teeth.
Turn the blade tightening lever clockwise until it hits against
the protrusion on the frame.
1. Tighten
2. Loosen
3. Protrusion
4. Lever
4
1
2
3
005898
To Next Page
Loading...
Need help?
General
