10
3. For Corner Joint and T-Butt Joint only
Clamp the vertical workpiece to the workbench.
For Miter Joint only
Clamp one workpiece to the workbench with the mitered edge facing up.
For Frame Joint and Edge-To-Edge Joint only
Clamp one workpiece to the workbench.
4. Set the depth of cut according to the size of biscuit to be used. Refer to
the table in the “Adjusting the depth of cut” section.
5. Adjust the angle guide height so that the blade is centered in the board
thickness.
Fig. E
004588
004589
004590
1. For Frame Joint
1. For Edge-To-Edge Joint
1
004591
1
004592
To Next Page
Loading...
Need help?
General
