Makita 4327 User Manual

7 ENGLISH
OPERATION
CAUTION:
• Alwaysholdthebaseushwiththeworkpiece.
Failure to do so may cause blade breakage,
resultinginaseriousinjury.
• Advance the tool very slowly when cutting
curves or scrolling. Forcing the tool may cause a
slanted cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
thebaseatontheworkpieceandgentlymovethetool
forward along the previously marked cutting line.
1
2
►1. Cutting line 2. Base
Bevel cutting
CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
• Raise the dust cover all the way before making
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
1
2
3
►1. Hex wrench 2. Bolt 3. Base
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel
angle by graduations. Then tighten the bolt to secure
the base.
1
2
►1. Edge 2. Graduation
Front ush cuts
1
2
3
►1. Hex wrench 2. Bolt 3. Base
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.

Makita 4327 Specifications

General

Stroke height	18 mm
No-load stroke rate	3100 spm
Input power	450 W
Power source	AC
Cutting depth in wood	65 mm
Product color	Black, Blue
Bevel adjustment	Yes
Bevel capacity (max)	45 °

Weight and Dimensions

Depth	217 mm
Width	77 mm
Height	197 mm
Weight	1800 g