Makita AF505 User Manual

5
INSTALLATION
Selecting compressor
• Select a compressor that has ample pressure and air output to assure
cost-efficient operation. The graph shows the relation between nailing
frequency, applicable pressure and compressor air output. Thus, for
example, if nailing takes place at a rate of approximately 60 times per
minute at a compression of 0.69 MPa (6.9 bar), a compressor with an air
output over 60 L/min is required. Pressure regulators must be used to
limit air pressure to the rated pressure of the tool where air supply
pressure exceeds the tool’s rated pressure. Failure to do so may result in
serious injury to tool operator or persons in the vicinity.
Selecting air hose
• Use an air hose as large and as short as possible to assure continuous,
efficient nailing operation. With an air pressure of 0.49 MPa (4.9 bar), an
air hose with an internal diameter of over 6.5 mm (1/4”) and a length of
less than 20 m (6.6 ft.) is recommended when the interval between each
nailing is 0.5 seconds. Air supply hoses shall have a minimum working
pressure rating of 1.03 MPa (10.3 bar) or 150 percent of the maximum
pressure produced in the system whichever is higher.
CAUTION:
• Low air output of the compressor, or a long or smaller diameter air hose
in relation to the nailing frequency may cause a decrease in the driving
capability of the tool.
Lubrication
To insure maximum performance, install an air set (oiler, regulator, air filter) as
close as possible to the tool. Adjust the oiler so that one drop of oil will be pro-
vided for every 50 nails.
When an air set is not used, oil the tool with pneumatic tool oil by placing 2
(two) or 3 (three) drops into the air fitting. This should be done before and after
use. For proper lubrication, the tool must be fired a couple of times after pneu-
matic tool oil is introduced.
Compressor air output per minute
Nailing frequency (times/min.)
0
10 20 30 40 50
0.78Mpa(7.8bar)
0.69Mpa(6.9bar)
0.59Mpa(5.9bar)
60
L /min
20
40
60
80
007304
004294
004295
1. Pneumatic tool oil
007180

Makita AF505 Specifications

General

Magazine capacity	100
Nail lengths supported	15 - 50 mm
Nail diameters supported	1.05 - 1.26 mm
Maximum operating pressure	8 bar
Minimum operating pressure	4 bar
Product color	Black, Green, Metallic
Belt hook included	Yes
Power source	Pneumatic

Weight and Dimensions

Weight	1400 g