Makita DC18RC User Manual

14 ENGLISH
To remove the pipe, turn the lever to the direction of the
arrowshowninthegureandpullthepipeoutwhile
pressing down the lock lever.
1
2
3
►1. Lever 2. Lock lever 3. Pipe
Installing the protector
WARNING: Never use the tool without the
guard illustrated in place. Failure to do so can
causeseriouspersonalinjury.
CAUTION: Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
1
2
3
►1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Cutter blade
CAUTION: When handling a cutter blade,
always wear gloves and put the blade cover on
the blade.
CAUTION: The cutter blade must be well pol-
ished, and free of cracks or breakage. If the cutter
blade hits a stone during operation, stop the tool and
check the cutter blade immediately.
CAUTION: Always use the cutter blade
with the diameter described in the section for
specications.
1
2
3
4
5
6
7
►1. Nut 2. Cup 3. Clamp washer 4. Cutter blade
5. Spindle 6. Guard 7. Spindle lock button
1. Mount the cutter blade onto the guard so that the
arrows on the cutter blade and protector are pointing in
the same direction.
1
1
►1. Arrow

Makita DC18RC Specifications

General

Input voltage	220-240 V
Output current	9 A
Input frequency	50/60 Hz
Battery recharge time	0.36 h
Battery voltage	18 V
Battery capacity	3000 mAh
Product type	Battery charger
Product color	Black
Brand compatibility	Makita
Compatible battery sizes	-
Number of batteries supported	1

Weight and Dimensions

Depth	156 mm
Width	190 mm
Height	84 mm
Weight	750 g
Cable length	2 m