Makita DGA520ZX1 User Manual

13 ENGLISH
When using a wire wheel brush
Optional accessory
CAUTION: Do not use wire wheel brush that
is damaged, or which is out of balance. Use of


CAUTION: ALWAYS use guard with wire

inside guard. Wheel can shatter during use and

Fig.13: 1.2. Wheel guard
Installing or removing X-LOCK wheel
WARNING: Never actuate the release lever of
the X-LOCK holder during operation. Make sure
that the X-LOCK wheel has stopped completely
when removing it.
󰀨
CAUTION: Use only original X-LOCK wheels
with the X-LOCK logo. This tool is dedicated to



-
ing, and cause the clamp tool to come loose.
CAUTION: Do not touch the X-LOCK wheel
immediately after operation.

CAUTION: Make sure that the X-LOCK wheel
and holder of the tool are not deformed and are
free from dust or foreign matters.
CAUTION: 
holder while installing or removing the X-LOCK
wheel.
CAUTION: 
release lever while installing the X-LOCK wheel. It

NOTE:


 
catches are in the unlocked position.

side, then pull the release lever from B side as
illustrated. The catches are set in the unlocked
position.
Fig.14: 1. Catch 2. Release lever
 
the holder.


 
catches snap into the lock position with a click and

Fig.15: 1.2. Holder 3.-
face 4. Catch
 

than the surface of the holder as shown in the



Fig.16: 1. Surface of the holder 2. Surface of the



B side as illustrated.

Fig.17: 1. Release lever
OPERATION
WARNING: It should never be necessary to
force the tool. The weight of the tool applies ade-


WARNING: ALWAYS replace wheel if tool is
dropped while grinding.
WARNING: NEVER hit the workpiece with the
wheel.
WARNING: Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc. This can cause loss of control and

WARNING: NEVER use tool with wood cutting
blades and other saw blades.


WARNING: Never actuate the release lever of
the X-LOCK holder during operation.
󰀨

WARNING: Make sure that the X-LOCK wheel

CAUTION: Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION: Always wear safety goggles or a
face shield during operation.
CAUTION: 󰀨
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION: 
one hand on housing and the other on the side
grip (handle).

Makita DGA520ZX1 Specifications

General

Brand	Makita
Model	DGA520ZX1
Category	Grinder
Language	English