5 ENGLISH
Vibration
-
Work mode: disc sanding
h, DS
) : 2.5 m/s
2
or less
2
Work mode: polishing
) : 2.5 m/s
2
or less
2
NOTE:
measured in accordance with a standard test method
NOTE:
WARNING: The vibration emission during
declared value(s) depending on the ways in which
the tool is used especially what kind of workpiece
is processed.
WARNING: Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
trigger time).
WARNING:
value is used for main applications of the power tool.
However if the power tool is used for other applica-
EC Declaration of Conformity
For European countries only
to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING Read all safety warnings, instruc-
this power tool. Failure to follow all instructions listed
Save all warnings and instruc-
tions for future reference.
(cordless) power tool.
Cordless sander polisher safety
warnings
Safety warnings common for sanding or polishing
operations:
1. This power tool is intended to function as a
sander or polisher. Read all safety warnings,
provided with this power tool. Failure to follow
2. Operations such as grinding, wire brushing,
-
formed with this power tool. Operations for
3. Do not convert this power tool to operate in
Such a con-
4. Do not use accessories which are not spe-
manufacturer.
safe operation.
5. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool.
6. The outside diameter and the thickness of your
accessory must be within the capacity rating
of your power tool.
7. The dimensions of the accessory mounting
-
ware of the power tool.
match the mounting hardware of the power tool
8. Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or acces-
sory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and
installing an accessory, position yourself and
bystanders away from the plane of the rotating
accessory and run the power tool at maximum
no-load speed for one minute. Damaged acces-
time.
9. Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As appro-
priate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stop-
ping small abrasive or workpiece fragments.
To Next Page
Loading...
Need help?
General
