EasyManuals Logo
Home>Makita>Saw>DSP600PT2J

Makita DSP600PT2J User Manual

Makita DSP600PT2J
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12 ENGLISH
Speed adjusting dial
Thetoolspeedcanbeadjustedbyturningtheadjusting
dial.Thespeedofthebladerotationincreasesasyou
increasethenumberonthespeedadjustingdial.
1
►1.Speedadjustingdial
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Number Blade rotating speed per
minute (min
-1
)
1 2,500 min
-1
2 2,900min
-1
3 3,900min
-1
4 4,900min
-1
5 6,300 min
-1
CAUTION: The speed adjusting dial is not
for using low speed rated saw blades but for
obtaining a speed which is suitable to material of
workpiece. Use only saw blades which are rated
for at least the maximum no load speed stated in
the SPECIFICATIONS.
NOTICE: The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past
5 or 1, or the speed adjusting function may no
longer work.
Electronic function
Thetoolsequippedwithelectronicfunctionareeasyto
operate because of the following features.
Overload protector
Whenthetoolisoverloadedandcurrentowsabove
a certain level, the tool automatically stops to protect
motor.
Constant speed control
Electronic speed control for obtaining constant speed.
Possibletogetnenish,becausetherotatingspeedis
kept constant even under load condition.
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
guretokeepitfrombeinglost.
1
►1. Hex wrench
Removing or installing circular saw
blade
CAUTION: Be sure the circular saw blade is
installed with teeth pointing up at the front of the
tool.
CAUTION: Use only the Makita wrench to
install or remove the circular saw blade.
Toremovethecircularsawblade:
1. Depress the lock-off button and lower the handle
alittle.Turnthelockingleverandlowerthehandleuntil
thelockpintsinthehole.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita DSP600PT2J and is the answer not in the manual?

Makita DSP600PT2J Specifications

General IconGeneral
BrandMakita
ModelDSP600PT2J
CategorySaw
LanguageEnglish

Related product manuals