4
1
2
3
5
1. Hard 2. Soft 3.4. Changed in three steps
5. Button
You can change the impact force in three steps: hard,
Every time the button is pressed, the number of blows
changes in three steps.
driving screws with good control.
In this mode, the tool drives a screw with low-speed
-
trigger, the impact force can be changed.
Impact force grade displayed
on panel
Maximum blows Purpose Example of application
Hard
3,900 min
-1
speed are desired.
tightening bolts.
Soft
1,600 min
-1
avoid screw thread breakage.
-
ening small screws such as M6.
3,900 min
-1
control.
NOTE:
impact force and speed are the same as hard mode.
NOTE:
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
To Next Page
Loading...
Need help?
General
