Makita DUR368L User Manual

15 ENGLISH
Cutting tool Protector
Cutter blade
(3-tooth, 4-tooth, and 8-tooth
blades)
Nylon cutting head
Plastic blade
Installing the protector
WARNING: Never use the tool without the
guard illustrated in place.Failuretodosocan
causeseriouspersonalinjury.
NOTE:Thetypeoftheprotectorsuppliedasthestan-
dard accessory varies depending on the countries.
For cutter blade
Attach the protector to the clamp using bolts.
1
2
►1. Clamp 2. Protector
For nylon cutting head / plastic blade
CAUTION: Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
1
2
3
►1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION: Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION: Be sure to remove the hex wrench
inserted into the tool head after installing the
cutting tool.
NOTE:Thetypeofthecuttingtool(s)suppliedasthe
standard accessory varies depending on the coun-
tires.Thecuttingtoolisnotincludedinsomespeci-
cations of the model.
NOTE:Turnthetoolupsidedownsothatyoucan
replace the cutting tool easily.
Cutter blade
CAUTION: When handling the cutter blade,
always wear gloves and put the blade cover on
the blade.
CAUTION: The cutter blade must be well pol-
ished, and free of cracks or breakage. If the cutter
blade hits a stone during operation, stop the tool and
check the blade immediately.
CAUTION: The cutter blade-fastening nut
(with spring washer) wears out in course of time.
If there appears any wear or deformation on the
spring washer, replace the nut. Ask your local
authorized service center to order it.
CAUTION: The outside diameter of the cutter
blade must be as follows. Never use any cutter
blade with larger outside diameter.
— 3-tooth blade : 230 mm
— 4-tooth blade : 230 mm
— 8-tooth blade : 230 mm

Makita DUR368L Specifications

General

Power Source	Battery
Battery Type	Lithium-Ion
Cutting Width	350 mm
No Load Speed	3, 500 - 6, 500 RPM
Spindle Size	M10 x 1.25 LH
Voltage	36V (18V x2)
Weight	4.5 kg