Makita DUR368L User Manual

19 ENGLISH
DUR368L
When using a nylon cutting head (bump & feed
type)
Thenyloncuttingheadisadualstringtrimmerhead
provided with a bump & feed mechanism.
Tofeedoutthenyloncord,tapthecuttingheadagainst
the ground while rotating.
1
►1. Most effective cutting area
NOTICE: The bump feed will not operate prop-
erly if the nylon cutting head is not rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures in the section for the
maintenance.
MAINTENANCE
WARNING: Always be sure that the tool is
switched off and battery cartridge is removed
before attempting to perform inspection or main-
tenance on the tool.Failuretoswitchoffandremove
the battery cartridge may result in serious personal
injuryfromaccidentalstart-up.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
TomaintainproductSAFETYandRELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
beperformedbyMakitaAuthorizedorFactoryService
Centers, always using Makita replacement parts.
Replacing the nylon cord
WARNING: Use only the nylon cord with
diameter specied in this instruction manual.
Never use heavier line, metal wire, rope or the
like.Failuretodosomaycausedamagetothetool
andresultinseriouspersonalinjury.
WARNING: Always remove the nylon cutting
head from the tool when replacing the nylon cord.
WARNING: Make sure that the cover of the
nylon cutting head is secured to the housing
properly as described below.Failuretoproperly
secure the cover may cause the nylon cutting head to
yapartresultinginseriouspersonalinjury.
Replacethenyloncordifitisnotfedanymore.The
method of replacing the nylon cord varies depending on
the type of the nylon cutting head.

Makita DUR368L Specifications

General

Power Source	Battery
Battery Type	Lithium-Ion
Cutting Width	350 mm
No Load Speed	3, 500 - 6, 500 RPM
Spindle Size	M10 x 1.25 LH
Voltage	36V (18V x2)
Weight	4.5 kg