Makita DUR368L User Manual

25 ENGLISH
Replacing the plastic blade
Replace the blade if it is worn out or broken.
When installing the plastic blade, align the direction of
the arrow on the blade with that of the protector.
1
2
►1. Arrow on the protector 2. Arrow on the blade
TROUBLESHOOTING
Beforeaskingforrepairs,conductyourowninspectionrst.Ifyoundaproblemthatisnotexplainedinthemanual,
donotattempttodismantlethetool.Instead,askMakitaAuthorizedServiceCenters,alwaysusingMakitareplace-
ment parts for repairs.
State of abnormality Probable cause (malfunction) Remedy
Motor does not run. Battery cartridge is not installed. Install the battery cartridge.
Battery problem (under voltage) Recharge the battery. If recharging is not effective,
replace battery.
Thedrivesystemdoesnotwork
correctly.
Ask your local authorized service center for repair.
Motor stops running after a little use. Battery's charge level is low. Recharge the battery. If recharging is not effective,
replace battery.
Overheating. Stopusingoftooltoallowittocooldown.
It does not reach maximum RPM. Battery is installed improperly. Install the battery cartridge as described in this
manual.
Battery power is dropping. Recharge the battery. If recharging is not effective,
replace battery.
Thedrivesystemdoesnotwork
correctly.
Ask your local authorized service center for repair.
Cutting tool does not rotate:
stop the machine immediately!
Foreignobjectsuchasabranchis
jammedbetweentheguardandthe
cutting tool.
Removetheforeignobject.
Thedrivesystemdoesnotwork
correctly.
Ask your local authorized service center for repair.
Abnormal vibration:
stop the machine immediately!
One end of the nylon cord has been
broken.
Tapthenyloncuttingheadagainstthegroundwhile
it is rotating to cause the cord to feed.
Thedrivesystemdoesnotwork
correctly.
Ask your local authorized service center for repair.
Cutting tool and motor cannot stop:
Remove the battery immediately!
Electric or electronic malfunction. Remove the battery and ask your local authorized
service center for repair.

Makita DUR368L Specifications

General

Power Source	Battery
Battery Type	Lithium-Ion
Cutting Width	350 mm
No Load Speed	3, 500 - 6, 500 RPM
Spindle Size	M10 x 1.25 LH
Voltage	36V (18V x2)
Weight	4.5 kg