Makita DUR369A User Manual

14 ENGLISH
NOTE
: During the reverse rotation, the tool operates only
for a short period of time and then automatically stops.
NOTE: Once the tool is stopped, the rotation returns
to regular direction when you start the tool again.
NOTE:
If you tap the reverse button while the cutting tool is still
rotating, the tool comes to stop and to be ready for reverse rotation.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at our service center.
CAUTION: This brake system is not a substitute for
the protector. Never use the tool without the protector. An
unguardedcuttingtoolmayresultinseriouspersonalinjury.
Electronic function
Constant speed control
The speed control function provides the constant rota-
tion speed regardless of load conditions.
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
WARNING: Always be sure that the tool is
switched o󰀨 and battery cartridge is removed
before carrying out any work on the tool. Failure to
switcho󰀨andremovethebatterycartridgemayresult
inseriouspersonalinjuryfromaccidentalstart-up.
WARNING: Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonalinjuryfromaccidentalstart-up.
Installing the handle
For DUR369A
1. Insert the shaft of the handle into the grip. Align
the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
1
3
2
►1. Grip 2. Screw 3. Shaft
NOTICE: Note the direction of the grip. The
screw holes will not be aligned if the grip is not
inserted in the correct direction.
2. Place handle between handle clamp and handle
holder.Adjustthehandletoananglethatprovidesa
comfortable working position and then secure with hex
socket head bolts.
1
3
2
►1. Hex socket head bolt 2. Handle clamp 3. Handle
holder
For DUR369L
1. Attach the upper and lower clamps on the damper.
2. Putthehandleontheupperclampandxitwith
hex socket head bolts as illustrated.
1
2 3
5
4
►1. Hex socket head bolt 2. Handle 3. Upper clamp
4. Damper 5. Lower clamp

Makita DUR369A Specifications

General

Brand	Makita
Model	DUR369A
Category	Trimmer
Language	English