Makita DUR369LZ User Manual

16 ENGLISH
For cutter blade
Attach the protector to the clamp using bolts.
1
2
►1. Clamp 2. Protector
For nylon cutting head / plastic blade
CAUTION: Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts. After
that, install the protector extension. Insert the protector
extension to the protector and then snap the clips on.
Makesurethatthetabsontheprotectorextensiont
into the slots on the protector.
1
2
4
3
6
5
►1. Protector 2. Clip 3. Protector extension 4. Cutter
5. Slot 6. Tab
To remove the protector extension from the protec-
tor, unclasp the clips by inserting the hex wrench as
illustrated.
1
2
►1. Hex wrench 2. Clip
Installing the cutting tool
CAUTION: Always use the supplied wrenches
to remove or to install the cutting tool.
CAUTION: Be sure to remove the hex wrench
inserted into the tool head after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Cutter blade
CAUTION: When handling a cutter blade,
always wear gloves and put the blade cover on
the blade.
CAUTION: The cutter blade must be well pol-
ished, and free of cracks or breakage. If the cutter
blade hits a stone during operation, stop the tool and
check the cutter blade immediately.
CAUTION: Always use the cutter blade
with the diameter described in the section for
specications.
1
2
4
5
6
7
3
►1. Nut 2. Cup 3. Clamp washer 4. Cutter blade
5. Spindle 6. Receive washer 7. Hex wrench
1. Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.

Makita DUR369LZ Specifications

General

Type	2-in-1 Brush cutter & String trimmer
Cordless	Yes
Head type	Blade & nylon line
Handle type	D-loop handle
Product color	Green
Rotational speed	7000 RPM
Cutting diameter (max)	430 mm
Power source	Battery
Battery voltage	18 V
Battery included	No

Weight and Dimensions

Length	1905 mm
Weight	5700 g