MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched
off
and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
3emove and check the carbon brushes
egularly. Replace when they wear down
o
the limit mark. Keep the carbon brushes
:lean and free to slip in
the
holders. Both
arbon brushes should be replaced
at
the
ame time. Use only identical carbon
]rushes.
5
Limit
mark
Fig.
II
nsert
a
minus screwdriver into the holes for carbon brush changeover on the base of the
daner. Remove the brush holder cap and take out the worn carbon brush. Replace with
new carbon brushes, then reinstall the brush holder caps and both holders.
eaning
iways brush
off
dirt, chips and foreign
atter adhering
to
roller surfaces.
.e
that water or
oil
does not enter the
mor.
Fig.
20
Oil
the
contact
portion
of the
I
Fig.
21
To Next Page
Loading...
Need help?
General
