3LTAGE WARNING: Before connecting the tool to a power source (receptacle,
Itlet, etc.) be sure the voltage supplied is the same as that specified on the
meplate of the tool. A power source
with
voltage greater than that specified
)r the tool can result
in
SERIOUS INJURY to the user
-
as well as damage to
le tool. If
in
doubt, DO NOT PLUG IN THE TOOL. Using a power source
with
oltage less than the nameplate rating is harmful to the motor.
;ROUNDING INSTRUCTIONS
\LL GROUNDED, CORD-CONNECTED
TOOLS:
In
the event of a malfunction or
Breakdown, giounding provides a path of least resistance for electric current to
educe the risk of electric shock. This tool is equipped with an electric cord having
an
equipment-grounding conductor and a grounding plug. The
plug
must be
ilugged into a matching outlet that is properly installed and grounded
in
ac-
zordance with all local codes and ordinances.
Do
not modify the
plug
provided-if
it
will
not fit the outlet, have the proper
outlet installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can result
in
a risk
of electric shock. The conductor
with
insulation having an outer surface that
is
green with or without yellow stripes is the equipment-grounding conductor.
If
repair or replacement of
the
electric cord or plug is necessary, do not connect
the equipment-grounding conductor to a live terminal.
Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if
in
doubt as to whether the tool is properly
grounded.
This tool is intended for use on a circuit that has an outlet that looks like the
one illustrated
in
Figure A. The tool has a grounding
plug
that looks like the
plug
illustrated
in
Figure A.
A
temporary adapter, which looks like the adapter
illustrated
in
Figure B and C, may be used
to
connect this
plug
to a 2-pole
receptacle as shown
in
Figure
B
if a properly grounded outlet is not available.
The temporary adapter should be used only
until
a properly grounded outlet can
be installed by a qualified electrician. The green-colored rigid ear,
lug,
etc.
extending from the adapter must be connected to a permanent ground such as
a properly grounded outlet box.
GROUNDING METHODS
FIG.
A
FIG.
B
~
FIG.
C
Groundibg
Pin
--
I
Grounding
Munl
To Next Page
Loading...
Need help?
General
