14 ENGLISH
OPERATION
CAUTION: THIS TOOL SHOULD ONLY BE
USED ON HORIZONTAL SURFACES.
CAUTION: Be sure to move the tool forward
in a straight line and gently. Forcing and exerting
excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of the
motor and dangerous kickback of the tool.
CAUTION: Be sure to feed water to a wet-type
diamond wheel during wet cutting operations.
Wet cutting with water supply tank
CAUTION: Avoid lling the water supply tank
with unclean water, such as muddy water, or else
the water outlet will be blocked resulting in dam-
age to the tool.
NOTICE: Be sure to drain out water from the water
supply tank completely after each use.
1. Open the lid-cap of the water supply tank, and ll
the tank with water. Then set the water-lled tank in the
water supply holder of the tool.
1
► 1. Lid-cap
2. Hold the tool rmly. Set the base plate on the
workpiece to be cut without the diamond wheel making
any contact.
Straight cutting
45° bevel cutting
3. Start feeding water to the diamond wheel by pull-
ing the water supply lever towards the “ON” (I) position.
Water ow can be adjusted by moving the water supply
lever. Turn the lever to the “ON” (I) position to increase
ow, and to the “OFF” (O) position to reduce ow.
3
2
1
► 1. Water supply lever 2. “ON” (I) position 3. “OFF”
(O) position
4. Turn the tool on and wait until the diamond wheel
attains full speed. Then move the tool forward over
the workpiece surface, keeping it at and advancing
smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance uniform.
5. Having nished operation, be sure to set the lever
in the “OFF” (O) position to cut ow o.
To Next Page
Loading...
Need help?
General
