90 Part Number STH039 8/13
ICE THICKNESS CHECK
The ice thickness probe is factory-set to maintain the
ice bridge thickness at 3 mm.
NOTE: Make sure the water curtain is in place when
performing this check. It prevents water from splashing
out of the water trough.
1. Inspect the bridge connecting the cubes. It should
be about 3 mm thick.
2. If adjustment is necessary, turn the ice thickness
probe adjustment screw clockwise to increase
bridge thickness, or counterclockwise to decrease
bridge thickness.
NOTE: Turning the adjustment 1/3 of a turn will
change the ice thickness about 1.5 mm.
Ice Thickness Check
Make sure the ice thickness probe wire and the
bracket do not restrict movement of the probe.
To Next Page
Loading...
Need help?
General