110 Part Number 80-01111-9 7/10
Safety Limit Notes
• A safety limit indication is completed before the
water pump starts. Water contacting the ice
thickness probe in the freeze cycle will cause the
harvest light to flash. Do not mistake a harvest light
flashing in the freeze cycle with a safety limit
indication.
• A continuous run of 100 harvests automatically
erases the safety limit code.
• The control board will store and indicate only one
safety limit – the last one exceeded.
• If the toggle switch is moved to the OFF position
and then back to the ON position prior to reaching
the 100-harvest point, the last safety limit
exceeded will be indicated.
• If the harvest light did not flash prior to the ice
machine restarting, then the ice machine did not
stop because it exceeded a safety limit.
To Next Page
Loading...
Need help?
General