003.
INSTALLATION & CONNECTION
• Connect the product according to the instructions in this manual.
• Connect the product only to the correct mains voltage as shown on the equipment.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit
the apparatus.
• Use only power cables of the type specied in the operating instructions or as marked on the product.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
A grounding plug has two blades and a third grounding prong.
• The wide blade or the third prongs are provided for your safety. If the provided plug does not t into your outlet, consult an electrician
for replacement of the obsolete outlet.
• Unplug the product during lightning storms or when unused for long periods of time.
• Do not install this equipment in a conned or a built-in space. Only install the equipment in a well ventilated and open location. The
ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.
• No naked ame sources, such as lighted candles, should be placed on the apparatus.
CLEANING & MAINTENANCE
Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped.
Clean only with dry cloth.
For more detailed cleaning and maintenance instructions, visit the website: http://www.marshallheadphones.com
DISPOSAL & RECYCLING INFORMATION
This appliance may not be treated as regular household waste. Management of WEEE (Waste Electrical and Electronic Equipment)
is applicable in member states of the European Union and other European countries with individual national policies on the
management of WEEE. If you need more information on the collection, reuse and recycling systems, please contact your local or
regional waste administration facility.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
To comply with FCC’s and Industry Canada’s RF radiation exposure limits for general population/uncontrolled exposure, this device must
be installed to provide a separation distance of at least 20cm from all persons.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
To Next Page
Loading...
Need help?
General
