10
ASSEMBLY INSTRUCTIONS
TO ATTACH BATTERY PACK
(fig 1)
1. Align the raised portion on the battery pack with the
groove on the bottom of the tool, then slide the battery
pack into the body of the tool.
2. Make sure that the battery pack latches securely.
TO DETACH BATTERY PACK
(fig 1)
Depress the battery-release button, located on the
front of the battery pack
INSTALLING AND REMOVING THE SAW
BLADE
(fig 2)
1. Detach the battery pack from the tool.
2. Turn the tool upside down.
3. Depress the tool-less blade clamp and hold it.
4. Insert the saw blade with the back of the blade resting
in the groove in the guide roller. Make sure that the
blade shank is completely inserted in to the blade
clamp. Then release the tool-less blade clamp.
5. Verify that the blade has been secured in place firmly by pulling on the blade.
6. To remove a saw blade, depress the tool-less blade clamp and hold it, then simply pull the blade out of the
blade clamp.
ASSEMBLY INSTRUCTIONS
CAUTION!
• When changing the blade, always wear protective gloves. The sharp edge of the blade can cause personal injury.
• The blade can be very hot after working. Allow the blade to cool after use. The blade can be dangerously hot.
WARNING!
• Check to see if the blade is correctly fastened. An incorrectly or insecurely fastened blade can become loose during operation
and cause a hazard.
• Always ensure that the tool is turned OFF before making any adjustments and installing any attachments.
To Next Page
Loading...
Need help?
General
