19
LASER DISTANCE FINDER/MEASURING TOOL - 057-4585-0
20
LASER DISTANCE FINDER/MEASURING TOOL - 057-4585-0
This Laser distance finder/Measuring tool been designed to be a low-maintenance tool.
However, in order to maintain its performance, you must always follow these simple directions.
1. Always handle the tool with care. Treat it as an optical device, such as a camera or
binoculars.
2. Avoid exposing the tool to shock, continuous vibration or extreme hot or cold temperature.
3. Always store the tool indoors. When not in use, ALWAYS store the tool in its protective case.
4. Always keep the tool free of dust and liquids. Use only a clean, soft cloth for cleaning. If
necessary, slightly moisten the cloth with pure alcohol or a little water.
5. Do not touch the lens with your fingers.
6. Check the batteries regularly to avoid deterioration. ALWAYS remove the batteries from the
tool if it is not going to be used for an extended period of time.
7. Replace the batteries when the empty battery indicator
is continuously displayed on the
LCD.
8. Do not disassemble the laser distance finder/measuring tool; this will expose the user to
hazardous radiation exposure.
9. Do not attempt to change any part of the laser lens.
PROBLEM POSSIBLE CAUSES SOLUTIONS
Tool cannot be
switched on
Batteries are installed
incorrectly
Reinstall the batteries according to
the polarity indicators in the battery
compartment
Batteries are low voltage Replaced with new batteries
The power key did not
contact well
Try to press it more firmly or send
for repair
Error codes on
LCD in measuring
Please refer to “Error
signals” above
Please refer to “Error signals” above
Short battery life Using incorrect batteries Use alkaline batteries
If the problem remains unsolved after performing the checks described above, call
the toll-free helpline, at 1-800-689-9928.
MAINTENANCE
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
