MasterCraft X-2 2008 User Manual

T
he following checks and services are essential to
safe boating and must be performed. Get in the
habit of performing these checks in the same order
each outing so that it becomes routine.
DO NOT launch or operate the boat if any
problem is found during the Safety Check. A prob-
lem could lead to an accident during the outing,
resulting in death or serious injury. Any and all
problems should receive attention immediately.
See your authorized MasterCraft service depart-
ment for assistance.
Before Each Operation
These tasks are best accomplished before the boat is
launched.
• Follow all engine and drive train pre-operation main-
tenance and safety checks as outlined in the engine
owner’s manual provided.
• Check the weather report, wind and water condi-
tions.
• Check for recommended on-board tools and parts.
• Check that all drain plugs are installed properly, in-
cluding bilge and rear drain.
• Check the propeller and shaft for damage.
• Check that there is an adequate supply of fuel.
• Check that the steering system operates properly.
• Check that required safety equipment is on board.
• Check that the windshield and extrusions do not show
any damage.
When boating, avoid using the windshield as an
aid for balance or getting out of a seat. is causes
undue stress to the window frame and could dam-
age it, which may not be covered under warranty.
• Checkthatthereextinguisherisfullycharged.
• Check that no fuel, oil or water is leaking or has
leaked into the bilge compartment.
• Check all hoses and connections for leakage or dam-
age.
• Check that all required Scheduled Maintenance
Checks and Services (see following sections) were
performed.
During Operation
• Check gauges frequently for operating conditions.
• Pay attention that controls operate smoothly.
• Note any excessive vibration.
After Operation
• Checkforuidleaks.
• In boats equipped with a ballast system, drain wa-
ter from the ballast system before placing the boat
on the trailer. If the boat has ballast-pumping assis-
tance to remove water from the ballast system, note
that the engine must be running at least 1500 RPM
duringthepumpingprocess(forbothllandempty
operations). This will necessitate draining water prior
to ceasing operation of the boat and loading on the
trailer. More information regarding ballast systems
appears in various sections of this Manual.
• Check the ns (where equipped), propeller,rudder
and shaft for damage after removing the boat from
the water.
 
 
2008 MasterCraft Owners Manual Page 7-1
 
 

MasterCraft X-2 2008 Specifications

General

Brand	MasterCraft
Model	X-2 2008
Category	Boat
Language	English