87
86
10.6 PCTV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
19) Plug the controller wire into the PCTV port on the back of the TV (Figure S).
20) Plug the net wire into the NET port on the back of the TV if wired internet will be used (Figure T).
21) If the PCTV will use wireless internet, plug the dongle into the port on the back of the TV (Figure U). Mount the dongle to the TV plastic
using double sided foam tape.
22) Connect the TV power wire and net wire to the 4 and 8 pin black connectors coming up the console mast from the base.
23) Attach the adaptor sent with the TV bracket kit to the coax cable coming from the TV (Figure V).
24) Attach the coax cable coming from the TV to the coax cable coming from the base of the unit up the console mast (Figure W).
25) Attach the controller wire end marked TO CONSOLE into the TV controller extension wire that should be sticking out the bottom of the
console from Step 9 (Figure X).
FIGURE S FIGURE T
FIGURE U FIGURE V
FIGURE W FIGURE X
10.6 PCTV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
26) Connect the rest of the console cable connections to the console, and install the console using the 5 screws removed in Step 2.
27) Install a back cover onto the TV to cover the wire connections, secure with 4 screws (Figure Y).
28) Plug a coax cable with a signal strength of 10 Hz into the base of the unit (Figure Z).
29) Plug an internet cable into the base of the unit (Figure AA) if using wired internet.
30) Plug a TV power wire into the base of the unit (Figure BB).
30) Power up the Climb Mill and test for function as outlined in Section 9.20.
31) Enter into Engineering Mode (see Section 6.1), and set the Audio Source setting for PCTV (Figure CC)
32) Program the TV as outlined in the TV Owner's Manual.
FIGURE Y FIGURE Z
FIGURE AA FIGURE BB
FIGURE CC
To Next Page
Loading...
Need help?
General
