55
8.21 TESTING THE ELLIPTICAL TRAINER
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO SETUP
AND TEST THE MACHINE:
1) Check that the console is set for elliptical (EP).
d. Press ENTER on Machine Type and make sure it is set for EP (Elliptical).
f. Press and hold the STOP key for 3-5 seconds to return to normal function.
1) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
2) After stopping movement, press the green GO key and begin using the machine.
3) Grasp the hand grips to check for proper heart rate response.
5) If everything functions properly, stop pedaling and the unit will reset to normal operation after 30 seconds.
CHAPTER 8: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
