Matrix MW200 User Manual

22
Electrical information
Warning! This appliance must be earthed.
The mains lead of this appliance has been fitted with a BS 1363A 13A
fused plug. To change a fuse in this type of plug, follow the steps below:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse
cover.
3. Replace fuse cover.
Important: Do not use the appliance without the fuse cover in
position.
How to connect an alternative plug
If the fitted plug is not suitable for your socket outlet, then it should be cut
off and disposed of safely to avoid the risk of electric shock. A suitable
alternative plug of at least 13A rating to BS 1363 should be used.
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as per the following page.

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm