Matrix MW200 User Manual

20
Failure codes and troubleshooting
The “Programme Indicators” also serve as a diagnostic display to help in
the event of a problem with the appliance.
Error Code
Error description Advice
P1 P2 P3 End
Inadequate water
supply.
Make sure the water inlet tap is fully
open.
Close the water tap, separate the
water inlet hose from the tap and
clean the filter.
Restart your machine, contact
Customer Care if the error resumes.
Continual fill error.
Close the tap and contact Customer
Care.
The waste water in
the machine cannot
be discharged.
Drain hose is blocked.
The filters of your machine might be
blocked.
Restart the dishwasher and
cancel the programme. If the error
continues, contact Customer Care.
Heater error. Contact Customer Care.
Alarm is active
against water
overflow.
Turn o the dishwasher and
disconnect the water supply.
Contact Customer Care.
Faulty electronic
card.
Contact Customer Care.

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm