15
CHAPTER 6: ENGINEERING MODE
1) To enter Engineering Mode, press & hold the INCLINE DOWN
and SPEED DOWN keys at the same time for 3-5 seconds until
Manager Mode appears on the display.
2) Press the INCLINE or SPEED keys until Engineering Mode
appears on the display (Figure A) and press ENTER.
3) To scroll between settings in the Engineering Mode, press the
INCLINE or SPEED keys.
4) Press ENTER to modify the settings once displayed.
5) Press any INCLINE or SPEED key to change the value of the
setting.
6) Once the setting is correct, press ENTER to save.
7) Press the EMERGENCY STOP to exit Engineering Mode..
6.1 USING ENGINEERING MODE
CUSTOM SETTING DEFAULT MINIMUM MAXIMUM UNIT DESCRIPTION
Disable Errors ON ON OFF N/A Resets error log.
Accomplished by pressing
INCLINE DOWN and
SPEED DOWN for 3-5
seconds.
Elevation Minimum 28 20 239 N/A Controls the low incline
parameter.
Elevation Maximum 230 20 239 N/A Controls the high incline
parameter.
Auto Calibration N/A N/A N/A N/A This function is to
calibrate the treadmill
incline.
Speed Units MILE MILE KILOMETER DISTANCE Measurement unit used
for calorie calculations,
distance, and speed.
Pause Time 30 SECONDS 5 SECONDS 10 MINUTES SECOND / MINUTE Controls the maximum
time the treadmill can be
paused during a workout.
Machine Type N/A N/A N/A N/A Sets the machine ID, not
editable.
Reset Defaults N/A N/A N/A N/A Reset the default values
to factory settings.
6.2 ENGINEERING MODE OVERVIEW
FIGURE A
To Next Page
Loading...
Need help?
General
