60
10.5 MYE TV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
CHAPTER 10: TREADMILL SPECIFICATIONS AND ASSEMBLY GUIDE
12) Attach the coax cable from the TV bracket kit to the coax cable coming up the console mast (Figure M). note: There is an adaptor to
hook the 2 male coax cable ends together included with the TV bracket kit.
13) Attach the 4 pin black connector side of the power wire to the TV POWER FOR EP port on the UCB (Figure N).
14) Plug the side of the controller wire marked TO CONSOLE into the TV port of the CSafe board in the console (Figure O).
15) Mount the front plate to the MYE TV using 2 screws sent with the TV bracket kit (Figure P).
16) Mount the TV to the bracket using 4 screws (Figure Q). note: Make sure the tabs of the front plate slide behind the console faceplate to
create a seamless look (Figure R).
FIGURE M
FIGURE N
FIGURE O FIGURE P
FIGURE Q FIGURE R
To Next Page
Loading...
Need help?
General
