61
10.5 MYE TV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
CHAPTER 10: TREADMILL SPECIFICATIONS AND ASSEMBLY GUIDE
17) Plug the coax cable into the port on the MYE TV (Figure S).
18) Plug the power wire into the port on the MYE TV (Figure T).
19) Plug the controller wire into the port on the MYE TV (Figure U).
20) Install the console back cover using the 4 screws removed in Step 1 (Figure V). note: Make sure to route the wiring through the holes in
the back cover so that none of the wiring is pinched (Figure W). The MATRIX logo portion of the back cover will not be used with a TV bracket.
21) Install the TV back cover using 4 screws (Figure X).
22) A coax cable with a signal strength of 10 Hz should be run to the treadmill and plugged in next to the power cord.
23) Enter into Engineering Mode and set the Audio Source setting to TV.
24) A channel scan should be done using the instructions included in the TV owner's manual.
FIGURE S FIGURE T
FIGURE U FIGURE V
FIGURE W FIGURE X
To Next Page
Loading...
Need help?
General
