87
TB1 - 5 pin connector from
the motor.
9.9 MOTOR REPLACEMENT
1) Turn off the power and disconnect the cord from the machine.
2) Remove the motor cover as outlined in Section 9.1.
3) Release the drive belt tensioner as outlined in Section 9.5.
4) Disconnect the motor power cable from the MCB (Figure A).
5) Use an 8 mm Allen wrench to remove the four motor mounting screws (Figure B).
6) Lift the motor away from the treadmill (Figure C).
7) Reverse Steps 1-6 to install a new motor. NOTE: When reinstalling the motor, make sure the red vibration pad is in place (Figure D).
8) Auto Calibration must ALWAYS be run when installing a new motor. (see Section 3.5)
FIGURE A FIGURE B
FIGURE C FIGURE D
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
