LEVELING THE TREADMILL
Use of shim or adding leveling foot.
NOTE: It is extremely important that the levelers are correctly adjusted
for proper operation. An unbalanced unit may cause belt misalignment
or other issues. Use of a level is recommended.
Remove the leveling shim provided on the underside of the treadmill. The
shim can be found mounted on the underside of the right hand side rail.
Remove the rear foot on the side of the treadmill that is resting low. Install
the shim as shown above and return the rear foot.
When installing the optional rear leveling foot accessory, remove the
existing rear foot. Replace with new leveling foot and fasten to the frame
using the existing fasteners that held in the half-moon foot.
BEFORE USING THE TREADMILL
Perform initial setup and calibrate the treadmill using the auto-calibration
feature found in ‘Manager Mode’ or ‘Engineering Mode’.
NOTE: DO NOT stand on the belt while the auto-calibration sequence is
in progress.
NOTE: DO NOT adjust incline until the initial setup and auto-calibration
are completed.
NOTE: DO NOT start the treadmill running belt or press any speed
buttons until directed to while tensioning the running belt.
21
To Next Page
Loading...
Need help?
General
