42
CHAPTER 8: PART REPLACEMENT GUIDE
8.20 TESTING THE BIKE
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO SETUP
AND TEST THE MACHINE:
1) Check that the console is set for bike.
a. Press and hold both LEVEL keys until Manager Mode appears on the display and press SELECT.
b. Use the UP or DOWN LEVEL keys to scroll to Machine.
c. Press SELECT when the display says Machine and make sure it is set for Bike (BI).
d. If Machine is not set for Bike (BI), change to BI using the UP or DOWN LEVEL key and press START to save.
e. Press the START key twice to return to normal function.
2) Without hitting start or entering any program modes, sit on the bike and hold the handlebars while pedaling to simulate exercising. While
moving, listen for any odd noises or squeaks.
3) After stopping movement, press the START key and begin pedaling.
4) Grasp the hand grips to check for proper heart rate response.
5) Press the level up and down buttons on the console and hand grips to make sure resistance is fully functional.
6) If everything functions properly, stop pedaling and the unit will reset to normal operation within 30 seconds.
To Next Page
Loading...
Need help?
General
