16 17
AFTER EACH USE (DAILY)
• Turn off the bike by unplugging the power cord from the wall outlet
• Wipe down the bike with a damp cloth. Never use solvents, as they can cause damage to
the bike.
• Inspect the power cord. If the power cord is damaged, contact Customer Tech Support.
• Make sure the power cord is not underneath the bike or in any other area where it can
become pinched or cut.
EVERY WEEK
Clean underneath the bike, following these steps:
• Turn off the bike.
• Move the bike to a remote location.
• Wipe or vacuum any dust particles or other objects that may have accumulated underneath the bike.
• Return the bike to its previous position.
EVERY MONTH
• Inspect all assembly bolts and pedals on the machine for proper tightness.
• Clean any debris off of the seat guide rail.
MAINTENANCE
WHAT KIND OF ROUTINE MAINTENANCE IS REQUIRED?
We use sealed bearings throughout our bikes so lubrication is not needed. The most important maintenance step is to simply wipe
your perspiration off the bike after each use.
HOW DO I CLEAN MY BIKE?
Clean with soap and water cleaners only. Never use solvents on plastic parts. Cleanliness of your bike and its operating environment
will keep maintenance problems and service calls to a minimum. For this reason, we recommend that the following preventive
maintenance schedule be followed.
To remove power from the exercise
bike, the power cord must be
disconnected from the wall outlet.
WARNING
HYBRID CYCLE™ ASSEMBLY
There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the
bike could have frame parts that are not tightened and will seem loose and may cause irritating noises. To prevent damage to the
bike, the assembly instructions must be reviewed and corrective actions should be taken.
Before proceeding, find your unit’s serial number located..
ENTER YOUR SERIAL NUMBER AND MODEL NAME IN THE BOXES BELOW:
» Refer to the SERIAL NUMBER and MODEL NAME when calling for service.
*The console serial number can be found in the Manager Mode.
WARNING
SERIAL NUMBER LOCATION
CONSOLE SERIAL NUMBER:
MODEL NAME: MATRIX
FRAME SERIAL NUMBER:
SERIAL #
PLACEMENT
bikes_om_r1.5.indd 16-17 9/9/11 8:19 AM
To Next Page
Loading...
Need help?
General
