33
7. Make a complete operational check of
ALL operating controls.
a. Microprocessor Controller (Computer) Programs and Selections...
1) Each microprocessor controller (computer) has been preprogrammed by the factory with the most
commonly used parameter (program) selections. If computer program changes are required, refer
to the computer programming manual, which was shipped with the dryer.
b. Dual Timer Dryers Check...
1) Heating Timer
2) Cool Down Timer
3) Temperature Selection Functions
J. SHUTDOWN INSTRUCTIONS
If the dryer is to be shutdown (taken out of service) for a period of time, the following must be performed:
1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2. Discontinue the gas or steam supply:
a. GAS MODELS...discontinue the gas supply.
1) SHUT OFF external gas supply shutoff valve.
2) SHUT OFF internal gas supply shutoff valve located in the gas valve burner area.
To Next Page
Loading...
Need help?
General
