McIntosh C49 User Manual

19
Factory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “FACTORY RE-
SET, (Hold INPUT)” appears on the Information
Display. Refer to figure 48.
3. Press and hold in the INPUT Control until “FAC-
TORY RESET, In Progress!” appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 49 and 50.
4. Press the Front Panel STAND/BY Push-button to
switch the C49 on.
Figure 50
FACTORY RESET
Completed!
Figure 48
FACTORY RESET
(Hold INPUT)
Figure 49
FACTORY RESET
In Progress!
Reset of Microprocessors
In the unlikely event the controls of the C49 stop func-
tioning, the microprocessors can be reset by perform-
ing the following:
1. Press the STANDBY/ON Push-button until the
STANDBY/ON LED Indicator switches Off in ap-
proximately five seconds.
2. Then release the STANDBY/ON Push-button and
the C49 will switch Off.
3. When the STANDBY/ON LED is illuminated
press the STANDBY/ON Push-button, the C49 will
resume normal operation.
Note: This can be performed with the C49 On or in
the Standby Mode.
Reset of the Microprocessors
Setup, con’t
i- i- i-
i- i- i-
i- i- i-
~ ~ ~

McIntosh C49 Specifications

General

Brand	McIntosh
Model	C49
Category	Amplifier
Language	English