116
Controls in detail
Seats
Removing and installing rear seat head
restraints
1 Release catch
Removing rear seat head restraints
왘 Fold the backrest forward
(
컄 page 240).
왘 Fold back head restraint (컄 page 115).
왘 Press head restraint release catch 1
and pull the head restraints out of the
guides.
왘 Fold the backrest back to its original
position.
Installing rear seat head restraints
Multicontour seat*
The multicontour seat has a movable seat
cushion and inflatable air cushions built
into the backrest to provide additional lum-
bar and side support.
The seat cushion movement, backrest
cushion height and curvature can be con-
tinuously varied with switches on the right
side of the seat after turning the SmartKey
in the starter switch to position 2 or press-
ing the KEYLESS-GO* start/stop button
twice.
Warning! G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the head re-
straint supports the back of the head at eye
level. This will reduce the potential for injury
to the head and neck in the event of an ac-
cident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
Do not interchange head restraints from
front and rear seat.
i
When installing the head restraints,
make sure that:
앫 you place the correct head restraint
on the middle seat. It is marked
with the letter “M” on the outside of
the metal bars.
앫 the head restraints engage fully.
To Next Page
Loading...
Need help?
General
